
|
PC Tab Alarm System - System Components
Not sure what you need?
CLICK HERE to
determine which components are necessary for your computers.
Check out our Computer Lab Packages! CLICK HERE for
details.
INSTALLATION INSTRUCTIONS
PC Tab Security Sensor - PCT-TSWT - $12.78
The PC Tab Security Sensor is the heart of the PC Tab Alarm System. It
combines the unique security sticker with a visible LED tamper
indicator. To attach this unique security sticker to your equipment,
you just peel and stick. Removing this sticker from the equipment
will set off the alarm. In case of any breach in security, the
LED will show which Tab has been tampered with.
By putting the sticker protecting the CPU across the cover and
chassis, it also prevents RAM Chip theft! |
  |
PCT-TAB - Security Sticker - $1.95
Extra security stickers can be purchased to keep on hand in case
you need to replace the existing sticker. |
 |
Connecting Wires -
PCT-CW06 - $ 4.95
PCT-CW12 - $ 5.95
PCT-CW25 - $ 8.95
PCT-CW50 - $12.95
The connecting wires have snap connectors at each end. Just
plug the connecting wires from sensor to sensor through the entire
cluster of computers/equipment you wish to secure, for a neat inconspicuous
configuration. Available in 6', 12, 25', and 50' lengths. Custom
lengths also available.
|
 |
RJ-11 Adapter - PCT-11SN - $3.27
RJ-45 Adapter - PCT-45SN - $3.27
|
| In a typical installation, you would install
a standard RJ-11 phone jack at the end of your zone wire, near the
equipment to be secured. This RJ-11 adapter plugs into that jack
to convert to the specialty PC Tab wires. An RJ-45 adapter is also
available in cases where you want to utilize an unused network wire
for your zone wiring. |
 |
End-of-Line Terminator - PCT-T56 - $3.27
The End-of-Line Terminator provides for a supervised alarm wire. 5.6K resistance
value. This terminator needs to be plugged into the unused port
in the very last security sensor in the cluster. If using
an alarm panel other than our DSC panel, you will need the Universal
Contact Module to ensure proper operation. |
 |
Universal Contact Module - PCT-UCM - $18.00
When using the PC Tab system on a panel other than a DSC alarm
panel, you must use the Universal Contact Module inside your alarm
panel to ensure proper operation. The Universal Contact Module
makes the PC Tab fully compatible with any alarm panel. It
monitors the PC Tab sensors and wires with a fully supervised loop
while providing a dry contact to your panel. One contact
module is needed for each cluster (zone). You do not need
the Universal Contact Module if you are using a DSC Alarm Panel. Board
size: 3" x 11/16".
INSTALLATION INSTRUCTIONS
|
 |

Central Alarm Panel - PCT-AP - $295.00
In
standing with the simplicity and full modular design of the system,
the PC Tab Control Unit is a full alarm panel designed to just
plug in and use
with no more setup than changing the PIN code.
Base Alarm Panel handles up to 8 'zones' or cluster of computers
on one unit
Hardwired or Wireless on same unit
Expanded Capabilities including dial-out
120 db siren for local alarm
Expandable up to 32 'zones' or clusters of computers on one unit with the 8-zone
Expander Module (see below)
INSTALLATION
MANUAL
INSTRUCTION
MANUAL |
 |
8-Zone Expander Module - PCT-APE - $195.00
Up to three 8-zone Expander Modules can be added to the Central Alarm Panel to protect up to 32 'zones' or computer clusters on one panel.
INSTALLATION INSTRUCTION
|
|